### Modelling the Components for a Load Flow Analysis

The Load Flow Analysis is done to determine the flow of real and reactive between different buses in a power system.  It also helps in determining the voltage and current at different locations.

To conduct a Load Flow Analysis, the components in a power system need to be modelled.  The modelling is done by developing equivalent circuits of the components, such as the generator, transmission lines and line capacitances.

The Generator equivalent circuit is shown below.

The Thevenin equivalent circuit.

This consists of a voltage source and a resistance and an inductance in series with the load.

E = V + IZ

where Z is the steady stage impedance

The Norton equivalent circuit consists of a power source and an admittance in parallel.

INorton = V/Z

INorton = YV

The load is modelled as a resistnce and inductance in a series circuit that is earth

Transmission lines

Transmission lines are modelled as

Short (less than 80 km)
Medium (80 to 250 km) or
Long lines ( 250 km and above)

You may also like